SY89610L Datasheet | Micrel Semiconductor

Description The SY89610L is a 3.3V, fully differential jitter attenuator and frequency synthesizer that accepts a noise clock between 19.44MHz and 694MHz, depending on I/O frequency selection. The output provides an ultra-low jitter clock frequency between 77.75MHz and 694MHz covering SONET/SDH, Gigabit Ethernet, Fibre Channel, SAS, SATA, and many other munication standards. The output jitter of the SY89610L is typically 1ps RMS. It has a 1k Hz to 10k Hz programmable loop bandwidth to acmodate different jitter attenuation applications and PLL requirements. The auto-tune circuit enables precision frequency calibration. The differential input includes Micrel’s unique, 3-pin input termination architecture that interfaces to LVPECL, LVDS or CML differential signals, (AC- or DC-coupled) as small as 100m V without any level-shifting or termination resistor networks in the signal path. For ACcoupled input interface applications, an on-board output reference voltage (VREF-AC) is provided to bias the VT pin. The outputs are patible with 400m V typical swing into 50Ω loads, with rise/fall times guaranteed to be less than 250ps. The SY89610L operates at 3.3V ±10% supply and the output can acmodate 1.8V to 3.3V operation with the dedicated output supply. The part is guaranteed to operate over the full industrial temperature range (- 40°C to +85°C). The SY89610L is part of Micrel’s Precision Edge® product line. Datasheets and support documentation can be found on Micrel’s web site at: .micrel.. Precision Edge® Features - Accepts high jitter input clock signal and attenuates it to provide Ultra-Low Jitter and Phase Noise clock signal at the output - Output Frequency Range: 77.75MHz - 694MHz - Input Frequency Range: 19.44MHz - 694MHz - Phase Noise and Jitter performance: - <2ps RMS Output Jitter Gen (12k Hz-20MHz) - Low Phase Noise: -80d Bc/Hz at 1k Hz offset - CML patible output signal - 3-pin input accepts an AC- or DC-coupled differential input (LVDS, LVPECL, and CML) - Unique,...